Nanning Maobo Traffic Equipment Sales Center

Before use, ensure that the battery in the remote control box is charged for enough time to keep the voltage of the power supply between -. . On the road section where the interception task is required, open the right side of the roadblock packaging box, roll out the roadblock roll, take off the elastic hook used to fix the roadblock, lean on the side of the roadside, and roll towards the road surface where the vehicle is to be intercepted.
. Connect the wiring between the remote control box and the roadblock head. Insert one end of the two-meter three-core connecting cable into the roadblock head connection jack and the other end into the remote control box roadblock output connection jack.
. Open the upper cover of the remote control box and pull the power switch to the built-in power supply. The power indicator light is on. The device enters the working state. Pull out the left receiving antenna and raise it up to increase the receiving distance.
When you need to perform the task of intercepting the suspect's vehicle, press and hold the remote control button. The power box will make a beeping sound. The interception indicator light on the power box will light up. The stainless steel hollow needle in the roadblock will automatically stand up. At this time, if you forcefully pass through the roadblock, the wheels will be stabbed. If a few stainless steel punctured hollow needles are inserted into the tire, the tire will deflate immediately within two seconds and the tire will be unable to continue driving and will have to stop.
After the interception mission is completed, release the remote control button and the erect stainless steel hollow needle will rotate back to its original position and enter the standby state.
. Recycling of remote-controlled vehicle blocking roadblocks. Roll the roadblock block into a round shape and use elastic hook straps to secure the roadblock block. Turn off the power switch of the remote control box and place the remote control box into the empty space in the middle of the roadblock block. Hold the roadblock box body with your left hand and your right hand. Roll the roadblock block into the box, put in the connecting cable, and fasten the box cover.